Cobalt-digital COMPASS 9086 Embedded Audio Loudness Processor Manual do Utilizador descarregar pdf (Página 26)

2 Installing a Rear I/O Module

2-4 9086-SD PRODUCT MANUAL 9086-OM (V4.3)

Figure 2-1 Rear I/O Module Installation

9086 Rear I/O Modules

Table 2-1 shows and describes the full assortment of Rear I/O Modules

specifically for use with the 9086.

Note: Rear I/O Modules equipped with 3-wire Phoenix connectors are supplied with

removable screw terminal block adapters. For clarity, the adapters are omit-

ted in the drawings below.

DSCN3483A.JPG

Align and engage mounting tab on Rear

I/O Module with the module seating slot

on rear of frame chassis.

Hold top of Rear I/O Module flush against

frame chassis and start the captive screw.

Lightly tighten captive screw.

DSCN3487A.JPG

Note: Rear I/O Modules RM-9086-C and -H occupy two rear

module slot mounting locations and use two captive screws.

Rear I/O Module RM-9086-G occupies three rear module

slot mounting locations and uses three captive screws.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 77 78

Sem comentários

Cobalt-digital COMPASS 9086 Embedded Audio Loudness Processor Manual do Utilizador Página 26